在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
创意集锦主页 > 创意集锦

关于理化板的存放注意事项

  关于理化板的存放注意事项:
  About the physical and chemical plate storage precautions:
  1、木笼尺寸必须大于产品,保证有足够强度和稳定性,同尺寸的边缘需对齐。若裁切后尺寸不一致,应将尺寸小的板材叠于尺寸大的上面,以维持受力的均衡,避免板材受力不均而变形。
  1, crib size must be greater than the product, ensure that there is enough strength and stability, with the size of the edge should be aligned. If after cutting size, small size board should be in the size of the above, maintain the balance of force, to avoid uneven plate stress and deformation.
  2、必须水平放置,禁止倾斜、架空堆放,货架应有足够和均匀的支撑,避免板材变形。产品卸货后不可将板材任意放在室外,搬运到施工楼层也需要有正确的木笼放置。www.4546.com
  2, must be placed, it is prohibited to tilt, aerial stacked, shelves should have enough and even support, avoid the deformation of sheet metal. Sheet after discharge of the product may not be arbitrarily on the outside, to the construction of the floor also needs to have the correct place crib.
  3、不论工地现场加工还是加工厂裁切后送工地存放,均建议在板材最上面和最下面铺防潮垫板,打开包装后最上面一片仍需翻面放置。
  3, whether on site or processing plant site to deposit, after cutting are recommended in the plate on the top and the bottom shop dampproof mat board, after opening the package has to be flip top a place.
  4、应存放于阴凉干燥场地、尽量避免日光照射和直接放置在地面上(可用木笼垫起)、或与外墙接触,避免受潮,在恒温、恒湿的室内环境中可层叠存放,堆放高度不得高于2米。整板堆放须注意产品防护,防止产品压损变形。
  4, should be stored in a cool and dry area and avoid sunlight and placed directly on the ground (or crib pads), or contact with the outer wall, avoid to be affected with damp be affected with damp, in constant temperature, and humidity of the indoor environment to layer deposited, stacking height shall not be higher than 2 m. The whole plate stacked must pay attention to product protection, prevent deformation of pressure loss of the products.
  本文由www.4546.com友情奉献.更多有关的知识请点击:/我们将用最先进的技术.最真诚的态度.为您提供最为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

<<
Baidu
sogou
>>