在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
工程案例主页 > 工程案例

无饰面复合防火板制作标准详解

1.无饰面复合防火板可设计为复合板薄抹灰保温系统,以及作为非透明幕墙中的保温层作用。
1 decorative composite fireproof board can be designed for composite board thin plastering insulation system, as well as the non transparent curtain wall of the insulation layer effect.
2.无饰面复合防火板墙保温系统可应用于刚劲混凝土、混凝土多孔砖、混凝土空心砌块、烧结多孔砖、加气混凝土砌块等材料为基层的外墙。
2 fire wall insulation veneer composite system can be applied to the strong concrete, concrete porous brick and concrete hollow block, porous brick, aerated concrete block wall material base.
3.复合板薄抹灰保温系统(图5.2.3)应由依附于基层墙体的界面层、找平层、粘结层、无饰面复合板、抹面层和饰面层构成。当基层墙体的表面状况满足外墙保温设计要求时,可不做界面层和找平层;抹面层中应内置玻纤网增强,饰面层材料宜为涂料或饰面砂浆。
澳门新莆京娱乐网站
3 composite board thin plastering insulation system (Figure 5.2.3) interface layer, leveling layer, adhesive layer, decorative composite board, surface layer and a facing layer shall be attached to the base wall. When the surface of the base wall to meet the design requirements of external wall insulation, can not do the interface layer and the leveling layer should be built; glass fiber net reinforced plaster layer, surface layer material should be paint or decorative mortar.
4.无饰面复合板用于非透明幕墙的保温层(图5.2.4)时,其构造由依附于基层墙体的界面层、找平层、粘结层、无饰面复合板、抹面层和幕墙板饰面层构成。当基层墙体的表面状况满足外墙保温设计要求时,可不做界面层和找平层;抹面层中宜内置玻纤网增强,饰面层可分为各类幕墙装饰板。
4 non veneer composite board heat insulation layer for non transparent curtain wall (Figure 5.2.4), which is composed of base wall attached to the interface layer, leveling layer, adhesive layer, decorative composite board, surface layer and wall facing layer. When the surface of the base wall to meet the design requirements of external wall insulation, can not do the interface layer and the leveling layer; plastering layer should be built in glass fiber reinforced decorative layer can be divided into various types of curtain wall decoration board.
5.复合板薄抹灰保温系统的使用高度不宜超过100mm。当高度超过100mm时,应以实测抗风压值进行计算,并应满足设计要求。
5 composite board thin plastering insulation system using height should not exceed 100mm. When the height is more than 100mm, the measured value of wind pressure should be calculated, and the design requirements should be met.

<<
Baidu
sogou
>>