在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

讲解在户外安装抗倍特的相关事项

  讲解在户外安装抗倍特的相关事项:
  Explain in outdoor installation against bate related items:
  抗倍特户外板的外墙系统由一下部分组成:抗倍特户外板,龙骨骨架,链接龙骨到结构上的锚固件,链接板材与龙骨的紧固件,保温材料等。www.4546.com
  Resistance times the special outdoor board exterior wall system is made up of the parts: resistance times outdoor board, keel skeleton, link the keel to the structure of the anchoring, link plate and keel fastener, insulation materials, etc.
  连接结构的骨架系统为主要受力结构,竖向结构的间距为410mm,使用通用的型钢,龙骨必须做防腐处理。竖向龙骨的截面尺寸根据当地不同的设计荷载选用。龙骨的截面宽度一般不宜小于60mm,高度根据受力设定而定。
  Connected skeleton structure of the system as the main load-bearing structure, vertical structure of spacing is 410 mm, use the general steel, keel must do anticorrosive processing. The section size of the vertical keel selected according to different local design load. The cross section width of keel usually should not be less than 60 mm, height according to force setting.
  竖向的龙骨通过支座连接的结构上,支座可以焊接到结构上的预埋件。当对旧的建筑物进行改建时,由于没有预埋件,可使用化学锚栓将支座固定到结构件上,根据现场的拉拔实验和设计荷载确定锚固件的使用。外墙不得使用普通膨胀螺栓。支座的间距同样需要通过荷载计算确定。
  Vertical keel through the bearing connection on the structure of bearing can be welded to the structure of embedded parts. When the renovation of old buildings, because there is no embedded parts, chemical anchor bolt can be used to support fixed on the structure, according to the drawing of field experiment and design load to determine the use of certain anchorages. Ordinary bolts shall be used for exterior wall. The spacing also need to be determined through load calculation of the bearing.
  板材与龙骨之间通过自攻螺丝或其他紧固件连接,紧固件必须要有防腐功能。
  Plate and keel connection through self-tapping screws or other fasteners and fasteners must have the anti-corrosion function.
  若抗倍特户外板外墙系统的后部有墙体,可以在墙体上使用保温材料做成外墙外保温的方式。对新建的建筑物,也可以在系统的后部使用轻质隔墙,然后在隔墙内部做保温处理。
  If resistance to bate outdoor board exterior wall system to the back of the wall, can be used on the wall thermal insulation materials exterior insulation way. For new buildings, but also can be used in the system at the back of the light partition, and then inside the wall heat preservation processing.
  板材的链接可以使用聚氨酯密封胶填缝,针头使用专用的材料补休。
  Sheet link can use polyurethane sealant caulking, needle use special materials not busy.

<<
Baidu
sogou
>>