在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

关于防火板隔墙的接缝处理工作

  关于防火板隔墙的接缝处理工作:
  The joint work of fire prevention board partition:
  1、接缝处理:在安装时东莞防火板与板材留有间隙4-6mm,用107胶水或强力胶调匀后用刮刀涂抹板材及缝隙处,然后用纸带或风格带粘贴压平。
  : 1, the joint in dongguan when installation of fire prevention board and board gaps 4-6 mm, with 107 glue or glue to make with scraper daub after plank and gaps, and then paste the flatten them with tape or style.
  2、涂料装饰:可以用喷涂、刷涂或滚涂,但刷涂时必须参看涂料的有关说明。www.4546.com
  2, paint decoration: can use brush or roller coating, spraying, but must see when brush paint.
  3、隔音墙体:如需墙体有较高的隔音效果,必须要求墙体和板材结合紧密密闭,再向空墙内填充矿棉,如龙骨两面采用两种不同厚度的板时,隔间效果更佳。
  3, sound insulation wall: if you need wall has high sound insulation effect, must demand sheet walls and combining tightly closed, to an empty wall filled with mineral wool, two sides such as keel using two different thickness of the plate, compartment effect is better.
  4、装饰面贴瓷砖:在浴室、卫生间、厨房、地下室等潮湿区域安装时,如需在板面贴瓷砖龙骨之间的距离必须缩短到400mm。墙体每隔三块板(约3.6mm左右)必须留有一条伸缩缝。
  4, decorative surface sticks ceramic tile in the bathroom, toilet, kitchen, basement damp area such as installation, if you need in the distance between the ceramic tile keel plate must be reduced to 400 mm. The wall every three boards (3.6 mm) must have a expansion joints.
  文章由www.4546.com贸易有限公司整理发表提供,详情请关注公司网站:/

<<
Baidu
sogou
>>