在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

防火板的施工具体注意事项

在安装板材时,材料必须使其达到室温标准并维持稳定的温度。材料不得安装于和正常使用场所极为不同之温度的地点。
When installing the plate, the material must be kept at room temperature and maintained at a stable temperature. Materials shall not be installed in a place with a very different temperature than the normal use of the site.
板材较其他天花板为耐撞击,但不得因此而置拜斯特天花板于墙角下层或极为容易受损坏的地方。肮脏空气会玷污任何天花板。因此设计上要注意空气的输送及回流以及空调系统的保养,空气要经过滤网并且不要让建筑内受工程中灰尘的影响。
Plate compared with other ceilings for impact resistance, but not so arranged beister ceiling in the lower corner or very easily damaged place. Dirty air will stain any ceiling. Therefore, to pay attention to the design of air transport and return air conditioning system and maintenance, the air must pass through the filter and do not allow the construction of the impact of dust in the project.
www.4546.com
防火板装饰平板及天花板属于室内装修产品,设计用于一般正常使用空间在15℃-30℃度安装,相对湿度不可超过70%。所有石膏、水泥、磨石子或其他潮湿性的工程都必须放置妥当。在安装之前,进行中或完成后,暖气通风及冷空调系统都得先行安装妥及可使用,以便维持正常的温度。
Fire plate decorative plate and ceiling of indoor decoration products, designed for the general normal use of space at 15 degrees -30 degrees Celsius, the relative humidity can not be more than 70%. All gypsum, cement, grinding stones or other wet projects must be put in place. Prior to installation, the heating and ventilation and cooling system must be installed and used in order to maintain the normal temperature.
防火板生产厂家建议勿使用保温材料覆盖于天花板或以天花板支撑保温材料。在高相对湿度状态下,如天花板承受附加重量,可能导致天花板下陷。若工程确需用如此之保温材料,必须用于正常使用环境(温度15℃-30℃,相对湿度最高达到70%)其保温材料之重量限制为最高不得超过1.269kg/m2,惟有卷装保温材料可被使用。而且务必垂直安装于骨架支点中,以支撑保温材料重量。
Fire prevention board manufacturers recommend not to use insulation material to cover the ceiling or ceiling support insulation materials. In high relative humidity conditions, such as the ceiling under additional weight, may cause the ceiling caved in. If indeed the need of engineering so insulation materials must be for normal use of the environment (temperature of 15 degrees to 30 degrees, relative humidity up to a maximum of 70%) insulation material weight limit for a maximum of not more than 1.269kg/m2 only roll insulation materials can be used. And must be installed vertically in the framework of the fulcrum, in order to support the weight of insulation materials.

<<
Baidu
sogou
>>