在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

无石棉硅酸钙板的隔墙安装步骤

1>通常情况下,作隔墙的新垄无石棉硅酸钙板采用纵向排布,即板的长边落在竖龙骨上;
1> normally, the new ridge partitions asbestos free calcium silicate board with vertical arrangement, namely the long side plate fell on the vertical keel;
2>板对接时要自然靠近,不得强压就位;
2> board docking near to nature, not strong in place;
3>特别注意门窗处板的排放,注意板缝不能落在平行于门边框,或窗边框的龙骨上,以避免由于门窗的经常开关产生震动而造成板缝开裂;
3 > special attention doors and windows in emissions, note seam can not fall on the keel of the parallel to the door frame or window frame, in order to avoid due to the frequent switch of door and window vibration caused by slab crack;
澳门新莆京娱乐网站
4>新垄硅钙板的两条长边都已倒角,如果墙体高于2440mm时,板水平接合的短边必须现场倒角(刨成宽度约25mm的斜边),以便更好的处理接缝。
4 new ridge calcium silicate board of two long sides of each of the chamfer, if wall is higher than 2440 mm, short side of the horizontal plate bonding must the scene chamfer plane into a bevel width is about 25mm), in order to better joint treatment.
5>弹线并标注板的固定点,同时作钻孔处理(孔径比螺钉头略大1-2mm,孔深1-2mm)固定点距板角40-55mm,固定点间距250-300mm。
5 the bomb line and marked in the fixed point and drilling processing (aperture ratio head screws slightly larger 1-2mm, hole depth 1-2mm) fixed pitch angle plate 40-55mm, fixed point spacing of 250-300mm.
6>固定无石棉硅酸钙板时,板与龙骨应做与钻孔,其孔径应比螺丝直径小1mm,用自攻钉固定时,应从板的中部向周边固定,且所有螺钉头均沉入板面1mm。在紧固时,板材必须与龙骨架钉牢。
> fixed asbestos free calcium silicate board, board and the keel should do and drilling, the aperture should screw diameter 1mm smaller than, with self tapping screws fixation, plate from the central to the surrounding fixed and head of all screws were sunk panel 1mm. In the fastening, the plate must be in prison with the Dragon skeleton.
本文来自:澳门新莆京娱乐网站更多精彩内容请点击我们的官方网站: http://www.tv-junky.com/我们将倾情为您解答。
This article from: Formica more exciting content, please click on our official website: / we will lean the sentiment to answer your questions.

<<
Baidu
sogou
>>