在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

防火板隔墙十大应用介绍

  1.配件:6mm以上的板材固定在框架龙骨上,要用3.5200mm的沉头螺钉固定,钉头低于板面0.5mm,以便保证饰面平整。
  Accessories: more than 6 mm plate fixed on the framework of keel, with a 3.5200 mm countersunk head screws, nail head below the surface of 0.5 mm, in order to ensure that ACTS the role of smooth surface.
  2.板材:一般情况下建议用6mm厚度以上的玻镁板作隔墙板。
  2. Plank: generally suggest using more than 6 mm thickness glass magnesium board partition board.
  3.板距:相临板材之间留缝距4-6mm,板材与地面之间必须留有5mm的间隙,螺钉安装中心距为150mm,距板边10mm,距离板角30mm。
  Plate spacing: between neighboring plate seam is from 4 to 6 mm, plank with ground must have 5 mm clearance between screw to install center distance is 150 mm, is apart from the edge to 10 mm, 30 mm distance of voids.
  4.安装:开始安装时,必须标好龙骨的准确位置,并作好记号。竖龙骨中心距离为450-600mm,墙体的连接处和门窗两侧安装时要装附加龙骨,如墙体高度大于2440mm时,须在板材连接处加装支撑龙骨。
  4. Installation: start the installation, it must be the good position of the keel, and well marked. Vertical keel center distance is 450-600 - mm, on both sides of the joint of the wall and door window installation to install additional keel, such as the wall height is greater than 2440 mm, must be in the plate joint with support keel.
  5.吊挂:卫生间或厨房间等吊挂重物处,必须用木板或龙骨加固,以免板材受到破坏。
  5. Hang: toilet or kitchen hanging heavy objects such as place, must reinforce the, with wood or keel sheet to avoid damage.
  6.接缝处理:在安装时深圳防火板与板材留有间隙4-6mm,用107胶水或强力胶调匀后用刮刀涂抹板材及缝隙处,然后用纸带或风格带粘贴压平。
  : 6. Joint in shenzhen when installation of fire prevention board and board gaps 4-6 mm, with 107 glue or glue to make with scraper daub after plank and gaps, and then paste the flatten them with tape or style.
  7.装饰面贴瓷砖:在浴室、卫生间、厨房、地下室等潮湿区域安装时,如需在板面贴瓷砖龙骨之间的距离必须缩短400mm。墙体每隔三块板(约3.6mm左右)必须留有一条伸缩缝。
  7. Decorative surface sticks ceramic tile in the bathroom, toilet, kitchen, basement damp area such as installation, if you need the ceramic tile keel plate must shorten the distance between 400 mm. The wall every three boards (3.6 mm) must have a expansion joints.
  8.隔音墙体:如需墙体有较高的隔音效果,必须要求墙体和板材结合紧密密闭,再向空墙内填充矿棉,如龙骨两面采用两种不同厚度的板时,隔间效果更佳。
  8. Sound insulation wall: if you need wall has high sound insulation effect, must demand sheet walls and combining tightly closed, to an empty wall filled with mineral wool, two sides such as keel using two different thickness of the plate, compartment effect is better.
  9.涂料装饰:可以用喷涂、刷涂或滚涂,但刷涂时必须参看涂料的有关说明。
  9. Paint decoration: can use brush or roller coating, spraying, but must see when brush paint explanatory.
  10.抗冲击墙体:建议您选用8mm以上的板或加一层板,第二张板须用长一些的螺丝钉加固。这种方法可增强抗冲击、隔热、隔音效果和防火性能。
  10. Shock wall: it is recommended that you choose more than 8 mm board or add a layer board, second board must be reinforced with a longer screws. This method can enhance the impact resistance, heat insulation, sound insulation and fire resistance.

<<
Baidu
sogou
>>