在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

镁固龙防火板施工流程介绍

切割:手工切割镁板,可用一般的薄片锯或手锯完成;如大量板材需要切割,建议使用电动圆盘齿锯;切割锯片是金刚石锯片;对圆或弧形的切割则可采用电动曲线锯进行施工;对厚度在小于或等于10mm的板材也可用刀片进行切割。
Cutting: manual cutting magnesium board, available general wafer sawing or handsaw completed; such as a large number of plate to be cut, it is recommended using electric circular saws; saw blade for cutting diamond saw blade; the circle or arc cutting can use electric curve saw construction; the thickness of less than or equal to 10 mm plate blade can also be used for cutting.
钻孔:可用电钻或开孔器任意在距边缘10mm以上的板面上钻孔或开方孔。
Drilling: drill hole or available at any distance 10mm above the edge on the surface or square hole drilling.
固定:可用气钉、自攻螺丝(建议先用带沉头的不锈钢自攻螺丝,不可用铁钉)。
www.4546.com
Fixed: the available gas screw, self tapping screws (recommended to use with stainless steel self tapping screws, countersunk head nails is not available).
粘结:可用粘结剂接壁纸、铝塑板、瓷砖等,也可将板面刮腻子、打光磨平后,外用涂料油漆等饰面(严禁使用酸性漆、胶涂覆于板面),具体方法视实际情况而定,可来电免费咨询。
Bond: adhesive can be used for connected wallpaper, aluminum composite panel, ceramic tile, board face scraping putty, polishing grinding after the topical paint finishes (it is strictly prohibited to use acid paint, glue coating to the surface of the board), the specific methods as actual situation and decide, can call free consultation.
填缝:A:将足够的嵌缝料填入大约3mm的缝内;
Sealing: A: sealing material will fill enough about 3mm slot;
B:用一把50mm宽的刮刀将穿孔纸带埋入接缝内,用嵌缝料完全覆盖表面;
B: punched tape embedded inside seams with a 50mm wide blade, a caulking material completely covering the surface;
C:等嵌缝料完全干透后,轻轻地砂光接缝表面;用一把200mm宽的刮刀抹施第二层嵌缝料;
C: sealing material is completely dry, gently sanding joint surface; with a width of 200mm with second layer sealing material scraper;
D:再次砂光接缝表面。
D: the surface of the sand seam again.
本文来自:www.4546.com更多精彩内容请点击我们的官方网站: /我们将倾情为您解答。
This article from: Formica HPL more exciting content, please click on our official website: / we will lean the sentiment to answer your questions.

<<
Baidu
sogou
>>