在线咨询
扫一扫

官方微信二维码
扫描加关注

全国免费服务热线
18560211715

返回顶部
新闻动态主页 > 新闻动态

玻镁板隔墙的施工的六项步骤

1、板材:一般情况下用6mm厚度以上的玻镁板做隔墙板。
1, plate: in general, with 6mm thickness of glass magnesium board to do partition board.
2、配件:6mm以上的板材固定在框架龙骨上,要用3.52mm沉头螺钉固定,钉头低于板面0.5mm以保证饰面平整。禁止使用铁钉安装。
2 accessories: more than 6mm plate fixed on the keel frame, to be with 3.52mm countersunk head screws, nail head lower than the plate 0.5mm to ensure smooth finish. Prohibit the use of nails installed.
3、安装:开始安装时,必须标好龙骨的准确位置,并做好记号。坚龙骨中心距离为450~600mm,墙体的连接处和门窗两侧安装时要装附加龙骨,如果墙体高度大于2440mm时,必须在板材连接处加装支撑龙骨。
3, installation: the beginning of the installation, you must mark the exact location of the keel, and make a good mark. The center distance of the center of the canal is 450~600mm, the connection of the wall and the door and window are installed at both sides of the installation of additional keel, if the wall height of more than 2440mm, must be installed in the plate connection support keel.
www.4546.com
4、板距:相邻板材之间留缝4~6mm,板材与地面之间必须留有5mm的间隙,螺丝安装中心距为150mm,距板边10mm,距板角为30mm。
4, plate distance: the gap between adjacent sheets 4~6mm, plate and the ground must be kept between 5mm clearance, the installation center distance of the screw is 150mm, from the edge of the board 10mm, from the plate angle of 30mm.
5、吊挂:卫生间或厨房间吊挂重物处,必须用木板或龙骨加固,以免板材受到破坏。
5, hanging: the bathroom or kitchen between the hanging weight, must be reinforced with wood or keel, so as not to damage the plate.
6、接缝处理:在安装时板材与板材之间留有4~6mm间隙,用108胶或强力胶调匀后用刮刀涂抹板材缝隙处,然后,用纸带或网格带粘贴压平。
6 and joint treatment: in the installation between the plate and the plate left 4 ~ 6mm gap, 108 glue or glue and mix thoroughly after use with a scraper smearing plate gap. Then, paper tape or mesh belt paste to flatten.
本文由www.4546.com提供帮助,更多的相关内容请点击:/我们将详情为您解答.欢迎您的光临!
This paper by Formica HPL help, more relevant content, please click: / us the details for you to answer. Welcome your presence!

<<
Baidu
sogou
>>